Z Wave Room Thermostat with LCD Display by Horstmann

Comes with our own UK Automation easy to follow instructions to get this fully working with Vera and Veralite. Without these you may have difficulty getting it to work correctly. If required select when purchasing.

The Horstmann HRT4-ZW is a battery operated Z-Wave enabled room thermostat. The desired temperature in the room can be set locally using the large dial on the front of the unit. It works in the same way as a normal room thermostat but is not hard wired to the heating source, instead control is achieved using Z-Wave wireless signals between the thermostat and the ASR-ZW receiver unit or a suitable switch attached to the heating source. In parallel suitable z-Wave control software or Z-Wave controller like Veralite or Fibaro Home Center 2 can be used to set the target temperature using Z-Wave. This enables you to control heating times and schedule zone heating. The thermostat itself does not have any internal timers but executes the wireless settings (COMMAND CLASS THERMOSTAT_SETPOINT) and the local setup.

Technical Spec.

HRT4-ZW Thermostat

• Z-Wave-Device Type: Portable Controller
• Power supply 2 x AAA alkaline batteries
• Temperature accuracy +/- 0.5°C
• Transmitter frequency 868MHz
• Dimensions 86mm x 86mm x36.25mm
• Temperature range 5°C – 30°C
• Enclosure protection IP30
• Operating temperature range 0-40°C

ASR-ZW Receiver Unit

• Z-Wave-Device Type: Routing Slave
• Power Supply 230V AC 50Hz
• Contact type Micro disconnection
  Voltage free
• Contact rating 3 (1) Amps 230v AC
• Operating temperature range 0-40°C
• Enclosure protection IP30
• Dimensions 86mm x 86mm x 36.25mm

Further Information

User and Installation manual for Horstmann HRT4-ZW and Receiver ASR-ZW Download here

Z-Wave information for the Horstmann HRT4-ZW and Receiver ASR-ZW Download here