X10 Outdoor Wireless Appliance Module - AM19RF-G - Schuko Plug

The X10 RF Appliance Module AM19RF is a new concept for the X10 range and is totally different to normal X10 plug in modules. This device can only be operated by X10 RF (wireless) signals and cannot be controlled by signal sent through the power lines. This means it can be directly controlled by any X10 remote control or X10 wireless transmitter without the need of a transceiver module. This makes it ideal for simple setups or where you only want to control a single or few devices.

The AM19RF RF receiver has the same features as the AM17RF, which means that it's a wireless controlled X10 module without any powerline switching. This means it's simple and easy to use, and can be used with any X10 wireless RF devices or the RFXCOM transceiver. Unlike the AM17RF, the AM19RF is suitable for outdoor use as it has a lid that protects the socket against splash water (IP44).

Features

To install, simply place the module between your socket and light/device. Press the 'learn key' until the LED starts flashing. The AM19RF is now ready to learn it’s X10 address. With any X10 RF device, send the desired House/Unit code command two times. The LED should stop flashing. From now on, you will be able to control your connected light/device remotely using the same house/unit code.

Plug Type

The AM19RF is also available with a France/Belgium plug type F

Technical information

Power Supply: 230V +/- 10 %, 50 Hz;
Electricity consumption: < 0,5W;
Power: 2,000W (lamps and halogen lights), 230W (motors), 3,000W (resistive load);
Frequency: 433.92 Mhz;
Responds to codes X10 RF: All units ON and OFF;
IP rating: IP44;
Temperature: -10 degrees C to 50 degrees C (operation), -20 degrees C to 70 degrees C (storage);
Dimensions: 115 x 55 x 70 mm