X10 Double Light Switch with dimming neutral wire required

Description of the X10 Double Light Switch

This X10 double light switch will replace a standard double light switch allowing your lights to be controlled manually or by X10 signals. This switch requires a neutral line unlike some X10 modules. This switch can switch on or off lights up to a total of 400W per switch (ie 200W per gang), it also has dimming facility.

Technical Specification

• Rated Voltage: 230VAC±10%ï¼?50Hz
• Lamp Load: maximum 400W in total for standard incandescent lights or 300W if controlling Low Voltage lighting with a suitable transformer.
• Minimum load required of 40W
• Suitable Temperature: -10ï½?50â??
• Dimensions of back control box 44mm x 47mm x 19mm deep

Functions:

• Control Lamp ON / OFF / Dim 
• X10 code is set electronically it is very easy and convenient to do
• Responds to “All Lights On/All Units OFF” X10 commands.
• Soft start / fade
• When switched on it returns to the light level it was set to when swtiched off 
• Signal driver (100mV).
• Compatible with any X10 controller.

THIS SWITCH REQUIRES A NEUTRAL WIRE