Marmitek X10 Appliance Module AW12 (Micro Module)
[AW12]

Special Offer 10% off normal price of £32.84

• This Marmitek MicroModule can be installed behind conventional wall switches or into wall outlets because of the extreme small size of the MicroModule (H = 4.6cm x W = 4.6 cm x D = 1.7cm, Minimum built-in depth 40 mm, advised 50 mm). The MicroModule is also ideal for installation into light fixtures or for use in areas with limited space such as rooms with lowered ceilings.
• Universal compatibility: No limitation in choosing brand, color or type of any wall switches and outlets.

This module can be controlled by normal switches or momentary switches connected to the module or remotely using the Marmitek X10 (PLC) signal via the mains. The module responds to the following Marmitek X10 PLC commands: On, Off and the optional Marmitek X10 commands All Lights On/All Lights Off/All Units Off when these have been programmed. Both normal switches (make/break) and momentary switches can be connected to the module. The input from the switch is connected to the live (brown wire, 230 V), the output from the switch is connected to the thin black wire (input) on the AW12 module. This is illustrated in figure A. The AW12 can also be used in a 2 way switching circuit, see Diagram B in 'How to install'.

When power is lost the module will retain the state it was in before the loss. (on/off) The AW12 uses 1-way X10 communications.

Click here for Data Sheet

NB requires a neutral connection.

For further information about Marmitek Micro Modules click on Marmitek comparison table

To install the Marmitek AW12, neutral and phase are required at the installation point.

• Switch off appropriate mains fuse and master switch!
• Take the wall switch out of the wall box.
• Disconnect all wires from the switch.
• Pull an additional Neutral wire if it is missing.
• Connect the live and neutral to the terminal wires of the AW12 as described in figure A.
• Connect the wire from the In-Wall module to the switch.
• Connect the live to the switch.
• Replace the wall switch.
• Switch on mains fuse and master switch.